Panasonic NE-1064F - Manual (Page 8)

^ » i i
. . . .
Before Operating
Make sure the oven is connected to a properly grounded electrical outlet.
When the door is closed, the display is still blank. When the door is opened, the display shows “0”.
For the detail operation, see the page on each feature.
This oven is preset at the factory for the following:
1, Memory Pads preset to High Power at the indicated heating times for single stage heating.
1- 10 sec.
2- 20 sec.
3- 30 sec.
4- 45 sec.
5 - 1 min.
6- 1 min. 30 sec.
7- 2 min.
8- 2 min. 30 sec.
9- 3 min.
0-3 min. 30 sec.
The Double Quantity Pad (x2) preset to automatically double the programmed time of each Memory Pad.
Example; press
DOUBLE ^
QUAmiTY - 2 mins.
2. Program Unlock.
3. Cycle counter set to “0” on all pads.
To set the power level:
Select power level before programming the cooking time.
Press
POWER
LEVEL
1 time................... HIGH
2 times................. MEDIUM HIGH
3 times............... , MEDIUM
______ 4 times..................LOW
5 times................. DEFROST
To set the cooking time: ® ..........
You can set up to 99 minutes 99 seconds.
Example 1: To set 15 minutes 45 seconds
Display Window
P''®ss [B-:' ® ^ (1
Example 2; To set 85 minutes 30 seconds
Press ^
I
When you press the START Pad, the display shows
1 hour 25 minutes instead of 85 minutes 30 seconds.
When selected cooking time is over an hour, the display
shows hours and minutes, but the oven works for your
setting time.
I H P S
Display:
The display will go blank (when the door is closed):
• at more than 1 minute interruption.
• at more than 1 minute after completion of heating
and removing food.
The display will flash “0”:
• continuously if food is not removed.
Oven Light:
Oven light will be turned on, when;
• you open the door.
• heating starts.
Oven light will be turned off, when:
• you close the door (no heating).
• heating finishes.
8 -