Kistler-Morse KM SVS2000 - Manual (Page 14)

ETHERNET/IP WIRING CONNECTION
PROFIBUS WIRING CONNECTION
DEVICENET WIRING CONNECTION
Plug ethernet cable into ethernet connector/plug (RJ45) in
the SVS2000 unit. Cable should ‘click’ into place.
Plug Profi bus cable into DB9 connector in the SVS2000
unit. Connector should screw into place.
To PLC or other DEVICENET peripheral equipment.
Acceptable cable types are Belden 3084A or equivallent.
To prevent ground loops, ground the signal shield wire only at 0ne end. To PLC or other DEVICENET peripheral equipment.
Acceptable cable types are Belden 3084A or equivalent. To
prevent ground loops, ground the signal shield wire only at
one end.
10
www.kistlermorse.com
97-1501-12 Rev. B