Windy Nation Rover Wind Turbine User Manual
Page 7

7
Section 2.0: Fasten Directional Tail to Yaw Mount
Figure 2
Step 1:
Locate the fastener bag labeled “Tail Assembly Fastener Set”. There are 7 stainless
steel bolts, 7 stainless steel k-lock nuts and 14 nylon washers. Slide one nylon washer onto each
stainless steel bolt. Attach the directional tail to the yaw mount using the 7 stainless steel bolts
with nylon washers. See Picture A in Figure 2 above.
Step 2:
Place the 7 remaining nylon washers onto the 7 stainless steel bolts that are securing
the Directional Tail to the Yaw Mount. Next, attach the 7 stainless steel k-lock nuts and tighten
to securely fasten the Directional Tail and Yaw Mount. See Picture B in Figure 2 above.