Panel, Sradio – Panasonic CQDRX900U User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Panel
Trouble
Cause
Step
Panel angle
unadjustable
Panel angle is set fixed.
Change tilt setting to ON.
SRadio
Trouble
Cause
Step
Much noise in FM
stereo and monaural
broadcasts
Station is too far, or signals are
too weak.
Select other stations of higher signal level.
Preset station is reset.
Battery cable is not correctly
connected.
Connect the battery cable to the terminal that is always
live.
HCD
Trouble
Cause
Step
CD is inside but no
sound
CD is upside down.
Place CD in the correction direction, the label side up.
CD is dirty.
Clean CD, referring to the section on Care of Discs.
CD sound skips, tone
quality is low.
CD is dirty.
Clean CD, referring to the section on Care of Discs.
Sound skips due to
vibration.
Mounting angle is over 30
degrees.
Adjust mounting angle to less than 30 degrees.
Instable mounting
Mount the unit securely with the mounting parts,
referring to the section on Installation.
CD is not ejected.
• CD is defective.
• Mechanical trouble
Open the panel and press [^]. If failure persists,
press the reset switch. If normal operation is not
restored yet, call the store where you purchased the
unit or the nearest service station to ask for repairs.
CQ-DRX900U
41