Panasonic CF-27 - Manual (Page 11)

Select your application
You are able to start working on your computer.
X note >
The power saving function is factory set, so if there is no input from a key, the
touch pad, or the external mouse for two minutes, the power to the LCD is cut
(ECO mode).
The LCD will resume operation when the touch pad is used or a key is pressed.
[System Devices] in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] may contain a device or devices bearing an exclamation mark or ques­
tion mark. This does not indicate a malfunction. Such a mark (exclamation or
question mark) will not be displayed if the operating environment of the device
showing the mark is corrected, by for instance installing the driver of the device.
Using the Touch Pad
Work Surface
Use the touch pad to move the cursor on the display and perform normal computer operations.
For instructions on how to handle the touch pad, refer to page 14.
The touch pad has the following two modes of operation.
Microsoft* IntelliMouse^ Wheel Mode
(Setting at the time of purchase)
Wheel mode operations (almost identical to
the case of using the Microsoft* IntelHMouse™
for scroll, zoom, etc., operations) are possible
for Microsoft® wheel function-compatible ap­
plications.
Microsoft® IntelliMouse™ is a mouse-type de­
vice that, in addition to the two conventional
buttons, incorporates a wheel able to rotate
forwards/backwards.
Scrolling Area
-j— Scrolling up/down
J
For the Pan and Auto Scroll functions, the entire
work surface of the touch pad can be used for scroll­
ing.
Original Mode
Only scroll operation is possible for appli­
cations not compatible with the Microsoft®
wheel function.
Even for applications compatible with the
Microsoft® wheel function, there are cases
where only vertical scrolling or only hori­
zontal scrolling is possible in this mode.
Scrolling Area
Scrolling up/down
I Possible when a check mark
I
is added for [Vertical].
Scrolling side-to-side
Possible when a check mark
V is added for [Horizontal].
□ : Typical mouse operations use this area.
When no check mark is added for ¡IntelliMouse Wheel mode], [Horizontal] and [Verti­
cal] of [Scroll Configuration], the entire surface can be used for typical mouse opera­
tions.
^ note >
When you are not sure whether an application is compatible with the Microsoft® wheel
function or not. try using both modes. Furthermore, depending on the application, there are
cases where scrolling may not be possible with either mode.
\
Changing the mode of the touch pad
1 Select Q from the taskbar and then select [Motion] or select [Motion] in [Start] - [Set­
tings] - [Control Panel] - [Mouse].
2 9 T o set the Microsoft® IntelliMouse™ Wheel mode
Add the check mark ^ for [IntelliMouse Wheel mode] of [Scroll Configuration],
• To set the original mode
Delete the check mark for [IntelliMouse Wheel mode] of [Scroll Configuration] and
add the check mark V for [Horizontal] and/or [Vertical].
3 Press [OK],
11