G%uitil0n, Setting a disc – Panasonic CF-VDD721 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting a Disc
7
Open the disc tray
Press the eject button and slowly pull out the tray,
2
Place a disc
Place the disc with the label facing upward in the
drive and push down until the center holder clicks.
Place a finger on the center holder and lift up on the
edge of the disc.
3
Close the disc tray
Close the tray without touching the eject button.
Label side up
(This illustration features
CF-72 series.)
(i
G%UiTil0N
D
• Do not apply excessive force to the tray in the open position, doing so could damage
the tray.
1
•
' if the PC Card does not work, there may be no interrupt request (IRQ) line available.
Deactivate unnecessary equipment using in the Setup Utility.
X
note
>
References to “CD-ROM” in the Setup Utility will not change when the DVD-ROM
Drive Pack is installed.
If the vibration of the DVD-ROM drive is excessively high, use the Setup Utility to
reduce the CD-ROM or DVD-ROM drive speed (by setting it to [Low] or [12x
speed])*.
* This .setting does not work for the DVD-ROM disc when this drive is used with the CF-71
series.