ThingMagic M5e-Compact - Manual (Page 166)

Set Application Commands
166 Command Set
which can be set and the supported settings. Additional parameters will be supported in
the future.
Protocol
Value
Parameter Option Value
0x05 (Gen2) Gen2 Session used for
Inventory commands.
= 0x00
N/A 0x00 - Session = S0 - (Default)
0x01 - Session = S1
0x02 - Session = S2
0x03 - Session = S3
Gen2 Target used for
Inventory commands.
= 0x01
0x01 (Static) 0x00 - Search Target = A
(
Default )
0x01 - Search Target = B
0x00 (Toggle A<>B)
Note: Searches using the
toggling behavior will
use the value Target
was in when the last
search ended for the
start of the next
search. To reset the
target this command
must be reissued.
0x00 - Search Target starts at A and
toggles to B during
Read Tag Multi-
ple (22h) after no more tag are found
with A.
0x01 - Search Target starts at B and
toggles to A during
Read Tag Multi-
ple (22h) after no more tag are found
with B.
Gen2 M Value used for
Inventory commands.
= 0x02
N/A 0x01 (M = 2)
0x02 (M = 4)
(
Default )
0x03 (M = 8)
Gen2 Q Value
= 0x12
0x00 = Dynamic - Automati-
cally adjust Q value. N/A
0x01 = Static - User specified
Q Value between 0 and 15. [1 byte] (0x00-0x0F)
Write Response Wait
Time used to reduce the
time a word write opera-
tion will wait for a tag
response before moving
to next word write.
= 0X3F 0x00 = Early Exit - If the tag’s
response to a word write is
detected it moves onto the
next word write, otherwise
waits for timeout Value. [2 bytes] - Wait timeout in microsec-
onds:
• Minimum = 1000us (0x03E8)
• Maximum = 21000us (0x5208)
Note: Default per Gen2 spec is
Early Exit with a 20000us
timeout. 0x01 = Fixed Wait Time -
Always waits the specified
timeout Value per word write.