Warning – Sage Nutri Juicer Plus BJE520UK User Manual
Page 15
14
PAge heAder.....
oPEratIng yoUr nEW aPPlIanCE
PrEParatIon of frUIt and
VEgEtaBlES for nUtrI JUICEr™
PlUS ExtraCtor
•
Only soft fruits should be used with the
Nutri Juicer™ Plus Extractor.
•
When using fruits with hard inedible
skins, such as mangoes, pineapple or
kiwi fruit, always peel before juicing.
•
When using fruits with a hard core such
as pineapple, always remove this
before juicing.
•
All fruits with pits, hard seeds or stones
such as nectarines, peaches, mangoes
and apricots must be pitted or deseeded
before juicing.
•
Passionfruit pulp, peeled kiwi fruit
and berries can be processed without
removing seeds.
notE
When using the Nutri Juicer™ Plus
Extractor, use low speeds (speed 1 or
2). Always ensure motor is running
before adding fruit and/or vegetables
to feed tube.
nUtrI JUICEr™ PlUS ExtraCtor SPEEd
Apricots (stone removed)
1
Bananas (peeled)
1
Kiwi fruit (peeled)
1
Mangoes (peeled, stone removed)
1
Melons (peeled)
1
Pears soft (stalk and core removed)
1
Pineapple (peeled and cored)
1
Raspberries
1
Strawberries (stalks removed)
1
Watermelon (peeled, seeds removed)
1
Use speed 2 to push out any remaining
fruit pulp in juice collector
2
WItH JUICE ExtraCtor or nUtrI
JUICEr™ PlUS ExtraCtor
1.
Wash selection of fruit and vegetables to
be juiced.
notE
Most fruit and vegetables such as
apples, carrots and cucumbers will not
need to be cut or trimmed to size as
these will fit whole into the feed chute.
Ensure vegetables such as beetroot,
carrots, etc. have all soil removed, are
well washed and trimmed of leaves
before juicing.
2.
Based on the type of fruit or
vegetable you are juicing/pureeing
select either the Juice Extractor or
the Nutri Juicer™ Plus Extractor.
WARNING
Do not put hard fruit and vegetables
(i.e. Carrots, apples, fresh beetroot,
etc.) or ice through juicer when using
Nutri Juicer™ Plus Extractor. This
could damage parts of the unit.
3.
Ensure the juicer is correctly
assembled. Refer to Assembling
your juicer. Ensure the juice jug (or
a glass) is placed under the spout
and the pulp container is in position
before commencing juicing.
4.
Plug the power cord into a 230V
power outlet. Turn the power on at
the power outlet. The LCD display
will illuminate.