Losi LOSB0222BD Manual User Manual

Page 3

Page 3

The Transmitter

1. Steering Wheel: Controls direction (left/right) of the model.
. Throttle Trigger: Controls speed and direction (forward/reverse)

of the model.

3. Antenna: Transmits signal to the model.
4. On/Off Switch: Turns the power on for the transmitter operation.
5. Indicator Lights: Green (top) light indicates adequate battery

power. Red (bottom) light indicates signal strength.

6. Steering Trim (ST. TRIM): Adjusts the “hands off” direction of the

model.

7. Throttle Trim (TH. TRIM): Adjusts the motor speed to stop at

neutral.

8. Steering Rate: Adjusts amount front wheels move when the

steering wheel is turned left or right.

9. Steering Reverse Switch (ST. REV): Reverses the function of the

steering when the wheel is turned left or right.

10. Throttle Reverse Switch (TH. REV): Reverses the function of the

speed control when pulled back or pushed forward.

11. Bottom Cover: Covers and holds the batteries powering the

transmitter.

Re-Binding the Transmitter to the Receiver

The Losi

™

DSM

radio system included in the Mini-Rock Crawler operates on .4GHz, and provides 79 different channels, which

are automatically selected when the transmitter and vehicle are turned on. The communication between the transmitter and
receiver starts in the few seconds after the transmitter and vehicle are both turned on. This is called the “binding process.” The
Losi DSM radio system will not interfere with previous technology radio systems that operate on 7MHz or 75MHz frequencies
and you will not receive any interference from them.
Although set at the factory, below are the steps required to re-bind your transmitter to the receiver should the need arise.
During the bind process there is a unique ID from the transmitter communicated to the receiver to ensure trouble free radio
operation.

Steps to Re-Bind the Receiver to the Transmitter

1. Ensure that the transmitter and vehicle are both turned off.
. Using the supplied Bind plug (which looks like a standard receiver

plug with a wire loop installed) insert the plug into the receiver
slot labeled “BIND”. Looking down on the receiver this slot would
be below the LED and is the furthest from the LED, or nearest to
the corner of the receiver.

Note: You do not need to remove any of the other plugs
to re-bind.

3. With the Bind plug installed, turn on the vehicle. Notice a blinking

orange LED within the receiver

4. Now you are ready to turn on the transmitter. You should notice

on the back of the transmitter a similar blinking orange LED under
the translucent cover.

5. Both the receiver and transmitter orange LED will stop blinking

and become solid indicating they have “bound” themselves
together.

6. Please turn off both the vehicle and transmitter to remove the

Bind plug from the receiver. Failing to remove the Bind plug will
cause the transmitter to attempt to rebind every time you turn on the vehicle and transmitter.

7. Turn on both the vehicle and transmitter to ensure operation. If the transmitter does not control the vehicle, please

repeat steps 1 to 6. Should this not correct the problem please call Horizon Service/Repair for further assistance.

8. The Bind process is complete. Your vehicle’s radio system should be ready for use.