Losi LOSB0206BD Manual - Manual (Page 5)

troubleshooting Guide
5
Doesn’t operate Battery not charged or plugged in Charge battery / plug-in
Receiver switch not “On” Turn on receiver switch
Transmitter not “On” or low battery Turn on / replace batteries
Motor runs but rear Pinion not meshing with spur gear Adjust pinion/spur mesh
wheels don’t move Pinion spinning on motor shaft Replace pinion gear on motor
Slipper too loose Check & adjust slipper
Transmission gears stripped Replace transmission gears
Drive pin in axle missing Check & replace
Steering doesn’t work Servo plug not in receiver Check if plug in / all the way
Servo gears or motor damaged Replace or repair servo
Won’t turn one direction Servo gears damaged Replace servo gears
Motor doesn’t run Motor plugs loose Plug in completely
Motor wire broken Repair or replace as needed
ESC damaged Call Electronics Tech
ESC gets hot Motor over-geared Put smaller pinion on motor
Driveline bound up Check wheels & trans for binds
Poor run time and/or Ni-MH pack not fully charged Recharge
sluggish acceleration Charger not allowing full charge Try another charger
Slipper slipping too much Check/adjust slipper
Motor worn out Replace motor
Driveline bound up Check wheels & trans for binds
Poor range/glitches Transmitter batteries low Check & replace as necessary
Transmitter antenna damaged Check & tighten
Battery low in truck Replace or recharge
Loose plugs or wires Check motor and power plugs
Slipper won’t adjust Drive pin missing in shaft Spur
gear face worn out Replace drive pin
Replace spur gear & adjust slipper
Mini Sprint Troubleshooting Guide