Losi LOSB0021 - Manual (Page 4)

4
Batteries and Charging:
The 810 uses rechargeable batteries such as NiMH or LiPo.
These batteries all have special requirements to preserve
performance and last a long time. Read all instructions and
precautions that are provided with the batteries intended to
be used in the 810.
• Read all instructions provided by the manufacturer
of the batteries.
• Responsible adult supervision is necessary while
charging batteries.
• Always check to ensure the polarity of battery
connection is correct.
• Never leave batteries unattended while charging.
• Never charge a battery while it is installed in the 810.
• Do not charge any battery that appears to have
any damage.
• If there are exposed wires do not charge or use the
battery until you have installed shrink-wrap or replaced
the complete wire.
If charging NiMH batteries, select a charger to meet your
requirements. Chargers can be of two primary types for
their source of power: a 100-240V wall charger, or one
which requires a 12V power supply. Follow the charger
manufacturer’s instructions and precautions during each use.
Supplied and Required Equipment
Supplied tools:
Four (4) Hex “L” Wrench Set
.050-inch, 1/16-inch, 5/64-inch, and 3/32-inch
Shock Bottom wrench
Turnbuckle/Shock Top wrench
Wheel Wrench (not pictured)
Tools You Will Find Handy
In addition to the tools included with the 810, you will find
the following both useful and in some cases necessary.
• Small flat blade and Phillips screwdrivers
• Needle-nose pliers
• Quality .050-inch, 1/16-inch, 5/64-inch, 3/32-inch,
1.5mm and 2.5mm hex (Allen) drivers
Recommended Accessories
Fuel – Preferably Nitrotane 20% Sport (LOSF0020). Note: This
fuel supports the engine warranty.
Fuel Bottle – The Losi 500cc fuel bottle (LOSB5201) is
suggested.
Glow Igniter (LOSB5221)
Rechargeable Receiver battery (LOSB9951)
Flat blade screwdriver with infrared temperature gauge
(LOSA99171)