Losi LST XXL Getting Started Guide - Manual (Page 3)

Caution HOT!
Page 3
Attach the glow plug ignitor (fig. 6A) to the glow plug. Put the standard hex of the starter shaft into the Spin-Start. Slide your
hand under the strap of the starter so that your index finger is on the switch at the bottom. Place the machined end of the
starter shaft into the matching hex socket in the back-plate of the engine (fig. 6B). Holding the starter securely, press on the
switch button and the engine should turn over and start up. If the engine does not turn over, it is probably flooded or the
battery in the starter needs to be recharged. Use a glow plug wrench to loosen the glow plug at least two turns and try again.
Raw fuel should come out around the plug. Tighten the plug and resume the starting procedure.
Follow the engine break-in procedure before attempting any racing or high-performance operation. Use caution when adding
fuel while the engine is running. Do not over fill or spill fuel outside the tank.
When you are done running your LST XXL, push the primer button down to stop the engine (fig. 7A). It may be necessary to
push the primer button down several times. If the engine does not stop, use the handle of a screwdriver or a rag to cover the
exhaust pipe exit (fig. 7B), being EXTREMELY careful not to burn your hand as this will be hot.
Start Your Engine
6A
6B
6C
Stopping the Engine
7A 7B