Dyras BSSV-2218WF User Manual

Page 6

BSSV-2218WF

12. Cable rewinder
13. Water tank cover lock
14. Roller wheels (two)
15. Small self-adjusting roller
16. Cleaning attachments
16a) Double-function wide suction head
16b) Narrow suction head with brush
16c) Narrow suction head
16d) Crevice suction head with brush
17. Brush holder
18. Filter unit
18a) Filter lock
18b) Sponge filter cartridge
18c) Mesh filter frame
19. Outlet cover with HEPA filter
20. Lock for outlet cover
21. HEPA-filter cartridge
22. Air outlet connector

POWER SUPPLY

The appliance should only be connected to 230V~ 50Hz electrical mains. Always verify

that the mains voltage at the place of use is the same as the voltage indicated in the

rating label on the appliance.

USING OF APPLIANCE

Assembling and preparing the vacuum cleaner

• Unpack the appliance and remove all the packing materials.

• Inspect the appliance and the accessories carefully to verify their soundness and undamaged condition. Only

perfectly sound and damage-free appliances may be connected to the electrical mains.

• Never leave the nylon packing bag, which is part of the package, within the reach of children who could play

with it.

1. Make sure the vacuum cleaner is unplugged. Lift the water tank cover lock

(13) and remove the water tank.

2. Use the water tank grip (8) to remove the water tank and filter unit together,

then remove the filter unit (20) from the water tank.

3. Fill the water tank with cold tap water up to the ‚Water Level’ mark on the front of the tank. Take care not to
over-fill the water tank. Over-filling the tank can cause moisture or dirt to damage the HEPA filter at the bottom
of the appliance. If the outside of the tank or the appliance is wet, wipe it with a dry cloth.

4. Reattach the filter unit to the water tank and place them in the vacuum

cleaner. Replace the water tank cover, ensuring all three ‚ears’ fit in the
appropriate openings and the lock clicks in place when the cover is closed.
Do not force the cover as any damage to the lock or the ‚ears’ will not be
covered by the manufacturer’s warranty.

Attaching accessories

Attaching the goose-neck pipe to the cleaner:
connect the end of the pipe into the round inlet on the vacuum cleaner
so the ‚lock’ at the end of the pipe is upwards. Please note that the
goose-neck pipe can only be fixed in this one position.