Support tube assembly, Intake funnel assembly, Warning – Craftsman 152.213351 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

2. Insert a 5/16-18 x 5/8" hex head screw (C) through

the exhaust flange, exhaust flange gasket and the
exhaust port flange. See figure 8.

3. Thread 5/16-18 flange hex nut (D) onto the 5/16-18

5/8" hex head screw, do not tighten completely.

See figure 8.

4. Repeat Steps 1,2, and 3 for the remaining holes.

Tighten all hardware.

SUPPORT TUBE ASSEMBLY

^WARNING

MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.

Fig. 9

1. Place support tube clamp (A) over lower support

tube holder (B). See figure 9.

2. Insert the lower support tube (C) into the lower

support tube holder and tighten support tube clamp.
See figure 10.

3. Place support tube clamp over top of lower support

tube.

INTAKE FUNNEL ASSEMBLY

warning

MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.

Fig. 11

1. Align the two holes in the Intake support brace (A)

with the two holes in the intake funnel (B).

See figure 11.