To replace headlight bulb, Interlocks and relays, To replace fuse – Craftsman 917.28925 User Manual

Page 26: To remove hood and grill assembly, Engine, Toadjustthrottlecontrolcable, To adjust choke control, To adjust carburetor

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

WARNING: Do not short battery ter

minals by allowing a wrench or any other
object to contact both terminals at the same

time. Before connecting battery, remove

metal bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected

first to prevent sparking from accidental

grounding.

REPLACING BATTERY

Lift seat pan to raised position.
Disconnect BLACK battery cable first

then RED battery cable and carefully

remove battery from tractor.
Install new battery with terminals in same
position as old battery.
First connect RED battery cable to posi

tive (+) terminal with hex bolt and keps

nut as shown. Tighten securely. Slide

terminal cover over terminal

Connect BLACK grounding cable to
negative (-) terminal with remaining hex
bolt and keps nut. Tighten securely.

A) Negative

(Black)
Cable

TO REPLACE HEADLIGHT BULB

1. Raise hood.

2. Remove bulb holder from the hole in the

backside of the grill.

3. Replace bulb in holder and install bulb

holder securely back into the hole in the
backside of the grill.

4. Close hood.

INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your

tractor to run poorly, stop running, or prevent

it from starting.
• Check wiring. See electrical wiring dia

gram in the Repair Parts section.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in

fuse.Thefuseholderislocatedbehindthedash.

TO REMOVE HOOD AND GRILL
ASSEMBLY

Raise hood.
Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at
sides, tiittowardengineand lift off oftractor.

When replacing hood, ensure to recon

nect the headlight wire connector.

ENGINE

TOADJUSTTHROTTLECONTROLCABLE
The throttle control has been preset at
the factory and adjustment should not be

necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.

TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be neces
sary. If adjustment is necessary, see engine

manual.

TO ADJUST CARBURETOR
Your carburetor has been preset at the factory
and adjustment should not be necessary.

However, minor adjustment may be required

to compensate for differences in fuel, tem

perature, altitude or load . Ifthe engine does
need adjustment, see engine manual.