Craftsman 917.271061 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING CHART
PROBLEM
CAUSE
CORRECTION
Will not start
• Out of fuel.
• Fill fuel tank.
* Engine not “CHOKED”
properly.
• See “TO START ENGINE”
in Operation section.
• Engine flooded.
• Wait several minutes before
attempting to start.
• Bad spark plug.
• Replace spark plug.
• Dirty air filter.
• Clean/replace air filter.
• Dirty fuel filter.
• Replace fuel filter.
• Water in fuel.
• Drain fuel tank and carbure
tor, refill tank with fresh
gasoline and replace fuel
filter.
• Loose or damaged wiring.
• Check all wiring.
• Carburetor out of adjustment.
Service Adjustments
• See “To Adjust Carburetor” in
section.
• Engine valves out of
adjustment.
• Contact an authorized
service center/department.
Hard to start
• Dirty air filter.
• Clean/replace air filter.
• Bad spark plug.
• Replace spark plug.
• Weak or dead battery.
• Recharge or replace battery.
• Dirty fuel filter.
• Replace fuel filter.
• Stale or dirty fuel.
• Drain fuel tank and refill with
fresh gasoline.
• Loose or damaged wiring.
• Check all wiring.
• Carburetor out of adjustment,
• See “To Adjust Carburetor” in
Service Adjustments
section.
• Engine valves out of
adjustment.
• Contact an authorized service
center/department.
Engine will not
turn over
• Clutch/brake pedal not
depressed
• Depress clutch/brake pedal.
• Attachment clutch is
engaged.
• Disengage attachment clutch.
• Weak or dead battery.
• Recharge or replace battery.
• Blown fuse.
• Replace fuse.
• Corroded battery terminals.
• Clean battery terminals.
• Loose or damaged wiring.
• Check all wiring.
• Faulty ignition switch.
• Check/replace ignition switch.
• Faulty solenoid or starter.
• Check/replace solenoid or
starter.
• Faulty operator presence
switch(es).
• Contact an authorized service
center/department.
Engine clicks but
• Weak or dead battery.
• Recharge or replace battery.
will not start
• Corroded battery terminals.
• Clean battery tenninals.
• Loose or damaged wiring.
• Check all wiring.
• Faulty solenoid or starter.
• Check/replace solenoid or
starter.
28