Attaching the wedge, beam and cylinder assembly, Attaching the latch bracket, Attaching the engine and pump assembly – Craftsman 247.287751 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ATTACHING THE WEDGE, BEAM AND
CYLINDER ASSEMBLY

•

Stand

the

wedge, beam and

cylinder assembly

upright.

•

Remove the four hex bolts, lock washers and hex

nuts from the beam mounting plates. A 5/8" and an

—11/16" wrench are required. See figure 6.

•

Roll the reservoir tank assembly in position against

the beam. Secure the beam mounting plates to the

beam with hardware just removed. Tighten securely.

ATTACHING THE LATCH BRACKET

• Remove the two he>x bolts, lock washers and hex

nuts from the beam, using two 1/2" wrenches.

• With the beam still in the upright position, place the

—pivot latch on the beam as shown in figure 7. Secure

with hex bolts, lock washers and hex nuts just re

moved. Tighten securely.

ATTACHING THE ENGINE AND PUMP
ASSEMBLY

•

Using two 1/2" wrenches, remove the four hex bolts,

lock washers and hex nuts which secure the base

of the engine to the bottom of the shipping carton.

•

Place the engine and pump assembly in position on

the engine mounting bracket as shown in figure 8.

—Secure

with

hardware

just

removed.

Tighten

securely.