Cleaning, Service and adjustments – Craftsman 917.273390 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLEANING
• Clean engine, battery, seat, finish, etc.
of all foreign matter.
• Keep finished surfaces and wheels free
of al! gasoline, oil, etc.
• Protect painted surfaces with auto
motive type wax.
We do not recommend using a garden
hose or pressure washer to clean your
tractor unless the engine and transmis
sion are covered to keep water out. Water
in engine or transmission will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass,
leaves and trash from tractor and mower.
SERVICE AND ADJUSTMENTS
A
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY
SERVICE OR ADJUSTMENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place gearshift lever in neutral (N) position.
3. Place attachment clutch in “DISENGAGED” position.
4. Turn ignition key to “STOP” and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the
right side of tractor.
1
.
2
.
3.
5.
6
.
Place attachment clutch in “DISEN
GAGED” position.
Move attachment lift lever forward to
lower mower to its lowest position.
Roll belt off engine pulley.
Remove small retainer spring, and
remove clutch spring off pulley bolt.
Remove large retainer spring, slide
collar off and push housing guide out
of bracket.
Disconnect anti-sway bar from chassis
bracket by removing retainer spring.
7. Disconnect suspension arms from rear
deck brackets by removing retainer
springs.
8. Disconnect front links from deck by
removing retainer springs.
9. Raise lift lever to raise suspension
arms. Slide mower out from under trac
tor.
MPORTANT: If an attachment other than
the mower deck is to be mounted on the
tractor, remove the front links and hook
the clutch spring Into square hole in frame.
TO INSTALL MOWER
1. Raise attachment lift lever to its highest
position.
Small Retainer Spring
Clutch Spring
Small Retainer Spring
Clutch Spring
Front Link
— Square Hole
Engine Pulley
Retainer Spring
Anti-Sway Bar
Coliar-
Housing
Guide
Retainer Springs
{Both Sides)
Large Retainer Spring
Bracket
Deflector Shield
21