Craftsman 132.24607 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

IMPORTANT: If you have not already done

so, you must disconnect the negative (-) termi
nal of the battery before completing the next
steps.

step 3

Repeat with the remaining dash adapter

nut (F) until seated on bottom surface of

the nut already installed. Use care to

ONLY tighten second nut. Tighten using
moderate force. Do not over tighten.

The assembly is now secure to the dash of
the tractor.

NOTE: If a hole was drilled in a dash not

equipped with mounting locations, {Step 1b)

you will need to slide the dash adapter spacer

(I) over hoses of the misting arm assembly (BB)
prior to proceeding.

Slide one dash adapter nut (F) over supply

lines and thread onto adapter until seated

on the bottom surface of dash. Tighten

using moderate force. Do not over

tighten.