To adjust motion control lever (see fig. 28), Transmission removal/replacement, To adjust steering wheel alignment – Craftsman 917.259172 User Manual

Page 23: Front wheel toe-in/camber, To remove wheel for repairs, Service ând adjustments

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SERVICE ÂND ADJUSTMENTS

TO ADJUST MOTION CONTROL LEVER
(See Fig. 28)

The motion control lever has been preset at the factory and
adjustment should not be necessary.

If for any reason the motion control lever will not hold its
position while at a selected speed, it may be adjusted at the

friction pack iocated on the right side of transmission.

<> Park tractor on level surface. Stop tractor by turning

ignition key to "OFF” position, and engage parking
brake.

» Adjust motion controi lever by tightening adjustment

locknut one half (1/2) turn.

NOTE: If for any reason the effort to move the motion
control lever becomes too excessive, reverse the above
adjustment procedure by loosening locknut 1/4 to 1/2 turn.

Road test tractor after adjustment and repeat procedure if
necessary.

TRANSMISSION REMOVAL/REPLACEMENT

Should your transmission require removal for service or
replacement, it should be purged after reinstallation and
before operating the tractor. See “PURGE TRANSMIS
SION” in the Operation section of this manual.

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right)

whenwheels are positioned straightfonward, remove steer
ing wheel and reassemble per instructions in the Assembly
section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.

TO REMOVE WHEEL FOR REPAIRS
(S

6 Fig. 29)

Block up axle securely.

Remove axle cover, retaining ring and washers to allow

wheel removal (rear wheel contains a square key - Do

not lose).

Repair tire and reassemble.

On rear wheels only: align grooves in rear wheel hub
and axle. Insert square key.

Replace washers and snap retaining ring securely in

axle groove.

Replace axle cover.

NOTE: To sea! tire punctures and prevent flat tires due to

slow leaks, tire sealant may be purchased from your local

parts dealer. Tire sealant also prevents tire dry rot and

corrosion.