Craftsman 358.792442 - Manual (Page 5)

changa in skin color or texture, or toss
of feeling in the fingers, hands, or
joints, discontinue the use of this toot
and seek medical attention. An anti­
vibration system does not guarantee
the avoidance of these problems.
Users who operate power tools on a
continual and regular basis must moni­
tor closely their physical condition and
the condition of this tool.
SAVE THESE INSTRUCTIONS
CARTON CONTENTS
Check carton contents against the fol­
lowing list.
Model 358.792442
• Brushcutter attachment
• Handlebar
• Handlebar mounting bracket for 1"
(2.5 cm) shaft
• Handlebar mounting bracket for 7/8"
g.2 cm) shaft
• Bracket cover (2)
• Shoulder strap
• Upper shoulder strap clamp
• Lower shoulder strap clamp (with
spacer tabs)
• Handlebar bracket screws (4)
• Shoulder strap damp screws (2)
• 4-point weed blade (assembled on
brushcutter attachment)
• Large nut for installing blade
• Retaining washer
• Cupped washer
• Meta! shield (assembled on brush­
cutter attachment)
• Trimmer head
• Plastic shield
• Wing nut (screwed onto plastic shield)
• Attachment Hanger
• Hex Wrench
• Container of line
Examine parts for damage. Do not use
damaged parts.
NOTE: If you need assistance or find
that parts are missing or damaged, call
1-800-235-5878.
ASSEMBLY
A WARNING: If received assembled,
repeat al! steps to ensure your unit is
properly assembled and ail fasteners
are secure.
• A hex wrench (provided) is required
for assembly.
INSTALLING BRUSHCUTTER AT­
TACHMENT
CAUTION:
When removing or instal­
ling attachments, place the unit on a
flat surface for stability.
Loosen the coupler by turning the
knob counterclockwise.
Coupler
LOOSEN
5.
TIGHTEN
Remove the shaft cap from the
brushcutter attachment (if present).
Position tocking/release button of
attachment into guide recess of
coupler.
Push the attachment into the cou­
pler until the iocking/reiease button
snaps into the primary hole.
Before using the unit, tighten the
knob securely by turning clock­
wise.
Coupler Primary Hole
Guide Recess
Locking/
Release
Button
Lower
Attachment
^WARNING: Make sure the lock-
ing/release button is locked in the pri­
mary hole and the knob is securely
tightened before operating the unit.
HANDLEBAR ASSEMBLY
A DANGER: RISK OF CUT. To avoid
serious injury, the barrier portion of the
handlebar must be installed as shown
on tile upper shaft of the powerhead to
provide a barrier between operator and
the spinning blade. Attach handlebar
mounting bracket above arrow on
safety warning decal on the upper
shaft (powerhead end of unit). Ensure
handlebar is positioned on mounting
bracket at the end of the arrow on the
handlebar decal.