beautypg.com

Sears trinary radio control, Matching your code in a new transmitter, Changing your code in receiver and transmitter(s – Craftsman 139.535006 User Manual

Page 23: Radio controls, Hill hi ü

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Sears Trinary Radio Control

Manulactured under 1 or more oi Ure following li S. patents: 3 445 848: 3 906.348; and 4 037 201

The coded signal in Sears Trinary RadioControls can be changed easily without the aid of aserviceman.The only tool

needed Is a flat blade screwdriver Choose your own code by changing position of switches numbered 1 through 9 on
the receiver code switch block. Changing the position of only one switch makes an entirely different code.

Radio Controls

MATCHING YOUR CODE IN A NEW TRANSMITTER

The original transmitter is preset at the factory to the same coded signal as the receiver. The code in any

NEW transmitters must be set to match the code In the original transmitter and the receiver.
PROCEDURE:

With visor clip off, remove screw in

the original and new transmitter{s) as illustrated in

Figure 1

. Carefully turn cades over (push button

sides up). Remove case tops as shown in

Figure 2.

CAUTION: Be careful not to move circuit board
components.

Place transmitter circuit boards side by side as shown

in

Figure 3,

Set the code switches in the new trans­

mitter to match those in the original transmitter. Use

a fingernail or screwdriver to slide the switches,.

Figure 1

Figure 2

Figure 3

----------------------- :;i

E

-----------------

-

5!||И1В!В r

V

Transmitter Circuit Board

Code Switches

CHANGING YOUR CODE IN RECEIVER AND TRANSMITTER(S}

DISCONNECT POWER TO OPENER BEFORE CHANGING THE CODE IN THE RECEIVER.

The receiver is fastened to the right side panel of the

opener chassis. Code switches are shown in Figure 4.

IF YOUCHANGETHE CODE IN YOUR RECEIVER, ALSO

CHANGE THE CODE IN YOUR TRANSMITTER(S}.

PROCEDURE:

Hold transmitter circuit board along­

side recelvercode switches as shown To change the
code, use a fingernail or screwdriver. Slide one or

more receiver switches to a plus, minus or center

(0) position.

Set code switches in the transmitter(s) to match thé

new receiver code settings.

IMPORTANT NOTE: Code settings must be ex­
actly the same in the receiver, transmitter and all
additional transmitters used to operate the door.
Please keep this instruction manual handy for
future reference.

Figure rt

1

c~~~n

•BiBiiîlîs c

Code

Switch

RED WHT BLK

щмицнитмццмшиии

ORN YEL

Hill HI Ü!@

h a 14 ъ:. 1 D 9

шеввееее

i-tf

23