Craftsman 919.155190 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To Convert to Remote Pressure

Feed

If the material to be sprayed is too

heavy for siphon feed or higher

volume application is desired, convert
to the pressure feed set up.

Remove the material cup from

fid/gun assembly. NOTE: Slide
release lever to the right, rotate
fid, and remove material cup.
Slide yoke, with built in socket

feature, over nut. Grip the yoke

and turn to loosen nut, after the
nut is loosened hand turn until lid
assembly can be removed from
gun.

3. The gun is now ready to be

connected to any pressure teed

tank with a standard 3/8" straight

pipe female connection. See
paint tank manufacturer's manual

for correct procedure,

4, See "Operation" Section to learn

how to use the spray gun,

NOTE: When replacing lid assembly to

gun assembly hand tighten nut and

then slide yoke over nut to tighten

securely.

Typical Pressure Feed Set Up

7- ENG

D297S3