Polarized plug, Extension cords, Replacement blade – Craftsman 900.370511 User Manual
Page 6: Assembly, Carton contents, To remove mower from carton
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

POLARIZED PLUG
To reduce the risk of electric shock, this
mower has a polarized plug (one blade is
wider than the other). This mower must be
used with a suitable polarized 2 wire or 3
wire extension cord. Polarized connections
will tit together only one way. Make sure
that the receptacle end of the extension
cord has large and small blade slot
widths. If the plug does not fit fully Into the
extension cord receptacle, reverse the
plug. If it still does not fit, obtain a suitable
extension cord. If the extension cord does
not fit fully into the outlet, contact a
qualified electrician to Install the proper
outlet. Do not change the tool plug or
extension cord in any way.
EXTENSION CORDS
Double-insulated tools have 2 wire cords,
and can be used with 2 wire or 3 wire
extension cords. Only round jacketed
extension cords should be used, and we
recommend that they be listed by
Underwriters Laboratories (U.L.)
ik
WARNING: To prevent eiectric shock
use only with an extension cord suitable
for outdoor use, such as SW-A, SJOW-A,
SOW-A, STW-A, STOW-A, SJW-A,
SJTW-Aor SJTOW-A.
An extension cord must have adequate
wire size (AWG or American Wire Gauge)
for safety, and to prevent loss of power
and overheating. The smaller the gauge
number of the wire, the greater the
capacity of the cable; that is, 16 gauge
has more capacity than 18 gauge. When
using more than one extension to make
up the total length, be sure each individual
extension contains at least the minimum
wire size.
To determine the minimum wire size
required, refer to the chart beiow; (Refer
to your mower’s nameplate to find the
Ampere Rating)
NOTE: Using any other length or rating or
cord will diminish the performance and
possibly the life of the eiectric motor.
SAVE THESE INSTRUCTIONS
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50 51-100
101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m)(30,4-45,7m)
240V
0-50
51-100 101-200
201-300
(0-15,2m)(15,2-30,4m) (30,4-60,9m)
(60,9-91,4m)
Ampere Rating
More
Not more
American Wire Gage
Than
Than
0 -
6
18
16 16
14
6 -
10
18
16 14
12
10 -
12
16
16 14
12
12 -
16
14
12 Not Recommended
REPLACEMENT BLADE
The replacement blade is stock # 33243
and is available at Sears Retail Stores and
Service Centers.
ASSEMBLY
CARTON CONTENTS
• Mulching Mower (Shipped with Mulch
Insert installed)
• Grassbag
• Grasscatcher frame
TO REMOVE MOWER FROM CARTON
Your mulching mower has been
completely assembled at the factory
except for the Grasscatcher.
U CAUTION: Do not lift the lawnmower
off the ground by holding the height
adjustment finger grip.
• Remove the Grasscatcher frame,
Grassbag and cardboard fillers.
• Remove the mower from the carton and
place al! four wheels on the ground or floor.
• Check the carton thoroughly and make
sure there are no loose pans.
To Unfold Handle
Raise the handle section Into place and
secure..................... . '
'
'
figure
I
secure by tightening the two knobs. See
I below.