Craftsman 247.77763 - Manual (Page 7)

Place the chipper chute over the weld studs
keeping the slotted side towards the bottom.
Loosely secure with the three hex nuts and bell
washers that were removed earlier. Do not fuliy
tighten the hex nuts at this point in the assembly.
See Figure 7.
• Align the support bracket with the holes in the
right side of the upper and lower handles where
the hex bolts were just removed. Push up
slightly on the chipper chute in order to better
align the holes in the support bracket with the
holes in the handles.
• Replace the hex bolts, saddle washers and
flange nuts.to affix the support bracket to the
handle assemblies. See Figure 7.
• Follow by tighten! ng al I hardware'securely fi rst
on the chipper chute, then on the support
bracket, and finally on the handle.
Attaching the Catcher Bag
• Place the catcher bag inside of handle
assembly. Slip the opening on the bag over the
discharge chute, making certain it is over the rib
on the discharge chute.
• Place the four straps on the top of the bag over
the upper handle, hooking them on the studs.
• Squeeze the clamp on the drawstring and pull
the drawstring tight. Release the clamp. See
Figure 8.