Craftsman 917.2922 - Manual (Page 6)

* « _________________________
UNPACK CARTON & INSTALL HAN­
DLE
AiCAUTION: Be careful of exposed sta­
ples when handling or disposing of carton­
ing material.
IMPORTANT:: When uNpacking and as­
sembling tiller, be careful not to stretch or
kinK cable(s).
« Cut cable ties securing handles.
« The handle may be assembled in high
or low position. Slowly lift handle as­
sembly up and align handle holes with
desired handle panel hole and slot.
« Loosely assemble hardware as shown.
Be sure the ‘
shorter {3/4" long) hex bolt is assembled
in lower hole of handle. Repeat for
opposite side. Tighten all hardware se­
curely.
® Cut cable ties securing tiller to skid and
remove tiller from skid.
Handle Panel
. Handle
Hex Bolts •
5/16-18x3/4"
Handles
Handle
Panel Bolts
Engine Bracket Halves
INSTALL DEPTH STAKE ASSEMBLY
® Loosen nut "A".
® Insert stake support between engine
bracket halves with stake spring down.
« Boit stake support to engine brackets
with bolts, lock washers and nuts.
Tighten securely. Tighten nut “A”.
® Depth stake must move freely. If it does
not, loosen support bolt.
Lock Washer
Flat
Washer
Hex Boit
5/16-18x1”
Depth
Stake
Support Bolt
Stake Spring
Hex Bolts, Lockwashers, and Hex nuts
HANDLE HEIGHT
® Handle height may be adjusted to better
suit operator. (See “HANDLE HEIGHT"
in the Service and Adjustments section
of this manual).
TILLING WIDTH
“ Tilling width may be adjusted to better
handle your tilling conditions (See ‘TINE
ARRANGEMENT’ in the Service and
Adjustments section of this manual).
TINE OPERATION
8 Check tine operation before first use,
(See ‘TINE OPERATION CHECK” in the
Service and Adjustments section of this
manual).