Storage – Craftsman 358.792441 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

NOTE:

Line glide plate must be rein

stalled in cutting head before inserting
new line.

4. Insert both ends of your line

through the proper holes in the

side of the cutting head.

5. Pull the line and make sure the

line is against the hub and ex

tended full through the positioning
tunnels.

Line against

_ ' the hub

Positioning/

Tunnel'

6. Correctly installed line will be the

same length on both ends.

REPLACING THE CUTTING HEAD

1. Align hole in the dust cup with the

hole in the side of the gearbox by
rotating the dust cup.

2. Insert a small screwdriver into

aligned holes. This will keep the
shaft from turning while removing
and installing trimmer head.

Screwdriver

While holding the screwdriver in

position, remove trimmer head by

turning clockwise.

Thread replacement trimmer head

onto the shaft by turning counterclock
wise.

Only tighten hand tight!

5. Remove the screwdriver.

BLADE REPLACEMENT

Refer to the ASSEMBLY section for
blade replacement instructions and il
lustrations.

STORAGE

«»WARNING:

Perform the following

steps after each use:
• Allow attachment and gearbox to

cool before storing or transporting.

• Store attachment with blade shield in

place. Position attachment so that
any sharp object cannot accidentally
cause injury.

• Store the attachment in a dry, well

ventilated area out of the reach of
children.

SEASONAL STORAGE

Prepare attachment for storage at end

of season or if it will not be used for 30

days or more.
If your brushcutter attachment is to be
stored for a period of time:

Clean the entire attachment.
Inspect the blade shield area and
clean any dirt, grass, leaves, or de
bris that has collected. Inspect the
blade and blade shield; replace a
blade that is bent, warped, cracked,
broken or damaged in any other way.
Lightly oil external metal surfaces.

Apply a coating of oil to the entire

surface of the blade; wrap it in heavy
paper or cloth.
Check entire attachment for loose
screws or nuts. Replace any dam
aged, worn or broken parts.

At the beginning of the next season,

use only fresh fuel having the proper

gasoline to oil ratio.