Sony MZ-R50 - Manual (Page 7)

Record an MD.
© Press and slide REC to the right.
"REC" lights up
@ Play the CD or tape you want to
record.
To stop recording, press ■.
"Data Save" or "Toe Edit” flashes while data
of the recording (the track's start and end
pciints, etc.) is being recorded. Do not move
or jog the recorder or disconnect the power
source while the indication is flashing in the
display.
To
Pause
Record from the end of the
previous recording.
Record partway through the
previous recording.
Remove the MD.
Press
I I '
Press I I again to resume recording.
END SEARCH and slide REC.
►, or to find the start point
of recording and press H to stop. Then
slide REC.
I and open the lid.^
A track mark is added at the point where you press II; thus the remainder of the track will be
counted as a new track.
Once you open the lid, the point to start recording will change to the beginning of the first track.
Check the point to start recording on the display.
If the recording does not start
•Make sure the recorder is not locked (page
20 ).
• Make sure the MD is not record-protected
(page 28).
•Premastered MDs cannot be recorded over.
•The level of the recorded sound is adjusted
automatically.
•You can monitor the sound during
recording. Connect the supplied
headphones with remote control to ( V
REMOTE and adjust the volume by
pressing VOLUME +/- (VOL +/- on the
remote control). This does not affect the
recording level.