Sony CAV-1 - Manual (Page 19)

t,;;
Basic Setup
If more than one set of IR codes is
available from the same manufacture
(such as Sony VTR 1 and VTR 2), choose
the set here.
The IR code set for the device is
automatically installed.
To confirm that the IR code has been
installed, press the button on the device's
control panel on the left and see if the IR
code is installed.
Note
• The IR codes of some remote commanders may
not be successfully installed even if “OK" has
appeared.
• If your VCR is connected to the interface box
with a LANC cable, select LANC from the
Maker/Format menu. Under this setting, the
power botton will not operate.
• When using a Sony CD changer connected
through the CONTROL A1 cable, click on lOOCD
in the Function Select menu and select Control
A1 from the Maker/Format menu (or Control A
if your Sony CD changer is the CDP-CX153).
Then select the number of the CD changer (CD!
or CD2) from the Category menu.
The CDP-CX151_does not operate when it is
connected through the CONTROL A1 cable.
• The IR codes of some Sony AV amplifiers
(including receivers), and audio amplifiers may
differ from the pre-installed codes in the
interface box. As a result, the devices will not
operate even after you have installed the IR
codes. If this occurs, do the procedure in “To
install IR codes not included in your CAV-1/
CAV-2" on this page.
• All IR codes that you have installed will remain
effective for a few days even if the AC adaptor is
disconnected.
To install IR codes not included in
your CAV-1/CAV-2
1
Do steps 1 to 3 of "For a Sony product or
a TV set, laser disc player, or VCR made
by another manufacturer" .
2
Select Other from the Maker/Format
menu below Command Set. All buttons
light up purple.
3
Click on Learning.
4
Click on any one of the buttons whose
IR code is to be installed.
The button is depressed.
(Continued)
19