Sony SCT-ID10 - Manual (Page 2)

Owner's record
The tmxlol and serial numbers are located at the
bottom of the base unit. Record the serial number
in the space pro\'ided below. Refer to these
numbers whenever you call upon your Sony-»-
dealer regarding the product.
Model No. SCT-IDIO
Serial No.________________ _________________
WARNING
To prevent fire or shock
hazard, do not expose the
set to rain or moisture.
To avoid electrical shock, do
not open the cabinet.
Refer servicing to qualified
personnel only.
For the customers in the
U.S.A.
A
CAUTION
RISK OF ELECTRIC SHOCK
00 NOT OPEN
CACmON: TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK)
. NO USER-SERVICEABLE PARTS INSIDE.
REFER SCRVICING TO QUALIFIED SERVICE PERSONNEL
This symbol is intended to alert the
user to the presence of uninsulated
"dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to alert the
user to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
* The graphical symbols are on the bottom
enclosure.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
INFORMATION
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection again^f harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures;
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/
TV technician for help.