Playing a cd in a car, To remove the batteries, To attach the battery compartment lid – Sony D-E226CK User Manual
Page 3: Battery life (approx. hours)(eiaj*), When to replace the batteries, Power, Using the dry batteries
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Playing a CD in a car
You can use vour CD player in a car as
illustrated below.
To connect your CD player to a car cassette
deck, you need the following acce.ssories:
• Car connecting pack
• Car battery cord
You can use the car mount plate for this CD
player.
Refer to the instruction manual of each
accessory tor details.
Notes
• Do not put the CD player on the dashboard.
• Do not leave the (.'D player in a car parked
under sunlight.
• If the sound is distorted, press SOUND until
the BASS indication disappears from the
display.
• Use a Sony ear connecting pack tor reducing
noise.
• Use only the car battery cord listed in the
Optional accessories.
It you use any other car
batterv cord, smoke, tire or malfunction mav
Switched ignition function
(when using the car battery cord)
With this feature, your CD player stops
automatically when you turn off the engine of
the car (T his function is not possible with
some cars depending on the model.)
►Power
Sources (E220IE226CK)
Using the dry batteries
Use only the following dry battery type for
your CD player:
• LR6 (size AA) alkaline batteries
Note
Be sure to remove the AC power adaptor when
using the dry batteries.
1 Open the battery compartment lid.
(rear)
Insert two LR6 (size AA) alkaline
batteries by matching the @ to the
diagram in the batter\' compartment.
To remove the batteries
Remove the batteries as illustrated below.
To attach the battery compartment
lid
If the battery compartment lid is detached by
an accidental drop, excessive force, etc., attach
it as illustrated below.
Battery life (approx. hours)(EIAJ*)
Battery life varies depending on how' the
player is used.
ESP OFF ESP ON
Two Sony alkaUne 25
C l
battenes LR6(SCi)
* **
‘ Measured value by the standard of EiA]
(Electronic Industries Association of lapan).
(When the unit is used on a flat and stable
pLice.)
** Charging time vanes depending on how the
rechargeable batteiy is used.
When to replace the batteries
You can check the remaining power of the
batteries in the display.
WJ^, Battery power is full.
Battery power is getting low.
?
^ Battery power is low'.
i
Lo batt* Batteries are depleted.
‘Beep sounds.
When the batteries are depleted, replace both
batteries with new ones.
Notes
• The indicator sections ot roughly shows
the remaining battery pow-er. One section does
not always indicate one-fourth of the batterv
power.
• Depending on operating conditions, the
indicator sections of rnay increase or
decrease.