Cisco ASR 1004 - Manual (Page 36)

36
Remove the Shared Port Adapter
The shared port adapter ships installed. These instructions are provided for future use. Cabling information is included with the
specific shared port adapter documentation.
Step 1 Attach an ESD wrist strap between you and an unpainted chassis surface.
Step 2 Disconnect all cables from the shared port adapter.
Step 3 Before removing any shared port adapter, shut down the interface so that there is no traffic running through the shared
port adapter when it is removed.
Note Removing a shared port adapter while traffic is flowing through the ports can cause system disruption.
Step 4 Remove the shared port adapter from the chassis slot. Grasp the handle and pull the shared port adapter or blank shared
port adapter from the router.
Figure 16 Installing and Removing the Shared Port Adapter
Step 5 Locate the shared port adapter slot guides inside the Cisco ASR 1004 Router. They are near the top, and are recessed
about one-half inch.
Caution The shared port adapter must slide into the slot guides under the chassis lid. Do not allow the shared port adapter
components to come in contact with the system board or the shared port adapter could be damaged.
Step 6 Carefully slide the shared port adapter into the shared port adapter slot and seat it. When installed, the shared port
adapter input/output panel should be flush with the face of the router.
Step 7 Reconnect any cables, including the shared port adapter and power cables, and place the cables through any
cable-management bracket.
ST AT US
STA TUS
C/ A
C/ A
A/ L
A/L
3
3
SPA-4XOC3-P OS
SPA-4XOC3-POS
0
1
2
C/ A
C/ A
STA TUS
STAT
US
0
A/ L
A/ L C/ A
C/ A
A/ L
A/ L C/ A
C/A
A/ L
A/ L C/ A
C/A
A/ L
A/ L
1
2
3
3
SPA-4XOC3-POS
SPA-4XOC3-POS
ASR1000-SIP10
PWR STATUS
STA TU S
ST AT US
C/ A
C/A
A/L
A/L
3
3
SPA-4XOC3-POS
SPA-4XOC3-POS
C/ A
STATUS
ST AT US
0
A/ L C/A
A/ L C/ A
A/ L C/ A
A/ L 1
2
3 SPA-4XOC3-PO S
ASR1000-SIP10
PWR STATUS
SPA-4XOC3-PO S
0
1
2
3
C/ A
A/L C/A
A/L
C/A
A/L
C/A
A/L
281
171