Cisco 8455dvb - Manual (Page 25)

23
Prepare the Remote Control to Operate Your TV (Optional)
The remote control is preprogrammed to operate the PVR. If you want the PVR remote control to operate
your TV also, you can programme the PVR remote control. In the TV Codes section of this guide, locate your
TV brand and the associated code number. If there are several codes listed, begin with the fi rst number and
follow these instructions.
Tips:
• Find the 3-digit code for your TV brand at the end of this guide.
• Press the Mode key on the remote control to switch between operating the PVR and the TV.
• In TV mode, the remote can control TV volume and TV on/off.
LED
T13735
Direct Programme Method
1. Turn on the TV.
2. Press the Mode key on the remote control until
the red LED on the Power key fl ashes twice.
3. Within 5 seconds, enter the 3-digit TV code .
The red LED will fl ash twice to indicate that the
code is accepted.
• If the LED lights steadily for 2 seconds after
you enter the TV code, there is a typing error.
4. Point the remote control toward the TV and press
the
Power key.
• The TV will go into Stand-By mode.
• If the TV does not go into Stand-By mode,
select a different code from the TV code list
and repeat steps 1 and 2.
5. Press the Mode key on the remote control until
the red LED on the Power key fl ashes twice.
6. Press 000 on the remote control to unlock your
TV code.
7. Test all the function keys on the remote control.
• If the function keys do not work correctly,
repeat the process using a different TV code.
Tip: If this method does not work, use the All
Code Scan Method to fi nd out which code your
remote control uses to operate your TV.