Dell Inspiron 5100 - Manual (Page 107)

Adding and Replacing Parts 107
To replace the hard drive in the hard drive bay:
1 Complete the instructions in "Before You Add or Replace Parts" on page 100.
2 Turn the computer over, and remove the hard drive screws.
NOTICE: When the hard drive is not in the computer, store it in protective antistatic
packaging. See "Protecting Against Electrostatic Discharge" on page 17.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force,
you may damage the connector.
5 Insert the drive into the bay, and push the hard drive until it is fully seated in the bay.
6 Replace and tighten the screws.
7 Use the Operating System CD to install the operating system for your computer (see
page 94).
8 Use the Drivers and Utilities CD to install the drivers and utilities for your computer
(see page 89).
screws (2)
hard drive