Canon LV-7585 - Manual (Page 16)

16
The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the
remote control codes prevents interference from other remote control units when several projectors or video
equipment next to each other are operated at the same time. Change the remote control code for the projector
first before changing that for the remote control unit. See “Remote control” in the Setting Menu on page 51.
Press and hold the MENU and a number button (1–8)
for more than 5 seconds to switch between the codes. 1
To initialize the remote control code, slide the RESET/
ON/ALL-OFF switch to “RESET,” and then to “ON.” The
initial code is set to Code 1. 2
MENU button
Remote Control Code
Number buttons
RESET/ON/ALL
OFF Switch
Press and hold the MENU and a number button
(1–8) that corresponds to the remote control code
for more than 5 seconds to switch between the
codes.
Part Names and Functions