Iris Sample Processing StatSpin® CytoFuge 12 Versatile Cytocentrifuge System - Manual (Page 9)

4
Operator Controls
Start Initiates the selected cycle
Stop/Open
Interrupts the cycle and releases the cover when the
rotor has stopped.
Cancels Programming Mode
Save
Enters Programming Mode to store speed, time and
acceleration settings
Acceleration Select
Depress to select acceleration profile - Low, Medium or
High
Up Increments program, speed or time
Down Decrements program, speed or time
CONTROL PANEL
To change the cycle speed use the arrow keys to the right of the SPEED display. Each key press will
change the speed by 10 rpm. Press and hold the key for 2 seconds to change the rpm in 50 rpm
increments.
To change the cycle time use the arrow keys to the right of the TIME display. Each key press will change
the time by 1 minute. Press and hold the key for 2 seconds to change the time in 10 minute increments.
To change the Acceleration rate press the key until the desired rate (high, medium, or low) is illuminated.
To change the Program use the arrow keys to the right of the PROG display.