Dustless Dustie - Manual

800.568.3949
dustlesstechnologies.com
FOR RIGHT ANGLE GRINDERS
2. Cut flanges to adjust height of shroud.
For best dust control, grinding wheel
should be 1/4 inch below shroud.
3. Install grinding wheel. See #2
for height.
5. Install Grinding wheel. For best dust
control, wheel should be 1/4 inch
below shroud.
6. Insert hose to port.
Instructions for Crack Chasing/Tuckpointing Application
1. Trim Flanges to adjust cutting wheel in middle of shroud.
2. Cut the Dustie on "CC Line" or "TP Line" depending on your
desired opening angle. Follow instructions 2-7 above.
3. Snap on Cover Plate* over open face.
*Not Included with all kits
This product was inspected and packaged carefully before being
shipped from the factory. If you should happen to need assistance
during assembly or operation, call 1-800-568-3949 for our
customer service department.
Always make sure grinder is UNPLUGGED when removing
or attaching front noseclip. Before use, refer to your tool
manual for warnings and instructions.
WARNING
4. Tighten band clamp.
Includes:
• Dustie™ shroud
• Band clamp
• Releasable zip tie
1. UN-PLUG GRINDER. Slip shroud
on grinder, flanges should be flush
with attachment.
7. Secure other end of hose to the electric cord with
releaseable tie provided.
Installation Instruction
OM013_0713