Wildview STC-TGL-5IR - Manual (Page 13)

STC-TGL5IR
www.wildviewcam.com Toll Free 888-304-6125
13
Programming your Wildview Camera
The following setting must be performed before you turn on the
camera.
1. Select the time out interval by sliding the time out toggle switch to
the desired preset time interval in minutes. 1 / 5 / 10 / 20 minutes.
2. Select the resolution setting by sliding the resolution toggle switch
to the desired resolution setting. Hi / Lo resolution.
3. Select capture mode: Slide the switch to 1 / 3 / 6 / AVI position.
4. Turn on the Camera to set the Date / Time stamp:
a. Slide the power switch to the PIR position.
b. Press and hold [SET] button for 2 seconds to enter date & time
setting mode.
c. Time and HH will blink. Press [UP] or [DN] to adjust the hour.
d. Press [SET] button to enter minute setting. Time and MM will
blink. Press [UP] or [DN] to adjust the minute.
e. Press [SET] button to enter the month setting. Date & MM will
blink. Press [UP] or [DN] to adjust month.
f. Press [SET] button to enter date setting. Date & DD will blink.
Press [UP] or [DN] to adjust date.