Kino Flo Trans-Flo User Manual
Page 8

A) Attach each TRANS-FLO circular connector tail to a locking lamps harness,
or single head extension, making sure to rotate the locking ring until it
“ clicks” into its locked position. Securely connect both ends to the harness
on the lamp before turning on the power.
B) With the ballast power switched off, attach the Power /Dim Cable to the
“POWER IN” port of the first ballast in the series.
D) Connect the Primary Power Feed (black) 3-pin U ground Edison plug to a
120 Volt AC non-dimming circuit. You do NOT connect the Dimming
Line ( D )to a dimmer circuit.
F) Switching the ballast to “NON-DIM” will turn on the lamps.
8
X04-25 SINGLE Head Extension, 25ft
X04-12 SINGLE Head Extension, 12 ft
Black, 4-pin male to female. Connects Trans-Flo
Ballast to Single Locking Harness. Maximum of 25ft
from Ballast to lamp for full dimming range control.
HAR-4801 4ft SINGLE Locking Harness
HAR-3601 3ft SINGLE Locking Harness
HAR-2401 2ft SINGLE Locking Harness
HAR-1501 15” SINGLE Locking Harness
PWC-C TRANS-FLO Jumper Coupler
To combine jumpers if more than 10 ft are required
between ballasts.