Human Touch Sharper Image bodySPA - Manual (Page 5)

humantouch.com
7
humantouch.com
6
take control
6
ENGLISH
7
Temperature — Sets the
desired temperature.
Seat heater — Turns the seat heater
on and off.
Timer — Sets the session timer. When the time runs
out, the BodySpa powers off automatically.
Minimum therapy session recommended is 30 mins.
Power — Turns the unit on and off.
NOTE: The power switch on the back of
the unit must be set to ON.
Using your BodySpa is easy – just turn it on, select the desired temperature and session
duration, then allow a few minutes for the unit to reach the desired temperature.
Turn on master power switch at back of unit.
Press and hold the power button to turn on the unit.
Use the temperature and to set the desired temperature (between 90 and 170 degrees).
TIP: Press and release the buttons to increment the time in 5-minute intervals; press and hold the button to increment the time quickly.
TIP: You can adjust the time and temperature during your session. The next time you turn
on your BodySpa, the time and temperature will be preset to the last session settings.
Allow five to ten minutes for the unit to warm up to the desired temperature. Once the temperature reaches
the set level, the heaters will turn off and on during the session to maintain a constant temperature.
Use the time and to set the length of time you wish to use the unit (between 5 and 60 minutes).
Press the Seat Heater button to turn on the Far Infrared bench lamp.
Press it again to turn off the lamp.
Slide the top door forward, and then flip it upward.
Open one of the side doors.
Step into the BodySpa, close the door and enjoy!
WARNING: DO NOT TOUCH THE HEATERS LOCATED IN THE FRONT
OF THE UNIT, TO PREVENT BURNS (Fig.2).
When you are finished with your session, press the power button
to turn off the unit. Allow your body to cool down before showering.
1
2
3
4
5
6
7
8
9
10
Top door
Side door
Fig.2
Tourmaline stones