Hanns.G HL225 - Manual (Page 22)

User’s Manual
22
ERROR MESSAGE & POSSIBLE SOLUTIONS
ƒ
CABLE NOT CONNECTED :
1. Check that the signal-cable is properly connected, If the connector is loose, tighten the
connector’s screws.
2. Check the signal-cable’s connection pins for damage.
ƒ INPUT NOT SUPPORT :
Your computer has been set to unsuitable display mode, set the computer to display mode given
in the following table.
FACTORY PRESET TIMING TABLE:
MODE RESOLUTION
HORIZONTA
FREQUENCY
(KHz)
VERTICAL
FREQUENCY
(Hz)
1 720×400 @70Hz 31.469 70.087
2 640×480 @60Hz 31.469 59.940
3 640×480 @67Hz 35.000 66.667
4 640×480 @72Hz 37.861 72.809
5 640×480 @75Hz 37.500 75.000
6 800×600 @56Hz 35.156 56.250
7 800×600 @60Hz 37.879 60.317
8 800×600 @72Hz 48.077 72.188
9 800×600 @75Hz 46.875 75.000
10 832×624 @75Hz 49.725 75.000
11 1024×768 @60Hz 48.363 60.004
12 1024×768 @70Hz 56.476 70.069
13 1024×768 @75Hz 60.023 75.029
14 1152×870 @75Hz 68.681 75.062
15 1152×864 @75Hz 67.500 75.000
16 1280×960 @60Hz 60.000 60.000
17 1280×1024 @60Hz 63.981 60.020
18 1280×1024 @75Hz 79.976 75.025
19 1440×900 @60Hz 64.981 60.050
20 1920×1080 @60Hz 66.587 59.934
21 1600×1200 @60Hz 75.000 60.000
22 1400 x 1050 @ 60Hz 64.744 59.948
23 1680 x 1050 @ 60Hz 65.290 59.954