Blizzard Lighting Komply Ribbon Flex - Manual

Komply™ Ribbon Flex
How to Cut Komply™ LED Ribbon Flex Strips
Step 1: Select the Cut Point
Step 2: Ribbon Connector
If you don’t need a ribbon connector, skip to step 3.
Step 3: Secure the End Cap
The final step is to simply glue the end cap back on to the end of the strip.
OK OK OK
OK OK
WWW.BLIZZARDLIGHTING.COM
After the strip is cut, carefully cut and clear
here to assure that there is enough space for
soldering ribbon connector wires.
Insert the connector wires through the end cap,
and solder the wires to the pads.
Do not cut here!
Do not cut here!