Blizzard Lighting Pocket Quasar (Rev A) - Manual (Page 2)

FEATURES
LASER SAFETY LABEL REPRODUCTION
Bottom
LASER SAFETY REQUIREMENTS
Lasers are one of the coolest effects available, and when they are used ap-
propriately, they will be fun, legal and harmless. To make sure that is the
case...
• Always set up and install all laser effects so that all laser light is at least 3
meters (9.8 feet) above the fl oor on which people can stand.
• After setting up, and before public use, test laser to ensure proper func-
tion. Do not use if any defect is detected. Do not use if laser emits only one
or two laser beams rather than dozens/hundreds, as this could indicate dam-
age to the diffraction grating optic, and could allow emission of higher laser
levels above Class 3R.
• NEVER point lasers at people or animals. Never look into the laser aper-
ture or laser beams.
• NEVER point lasers in areas in which people can potentially get exposed,
such as uncontrolled balconies, etc.
• NEVER point lasers at highly refl ective surfaces, such as windows, mirrors
and shiny metal. Even laser refl ections can be hazardous.
• NEVER point a laser at aircraft, this is a federal offense!
• NEVER point un-terminated laser beams into the sky.
• NEVER expose the output optic (aperture) to cleaning chemicals.
• NEVER use laser if the laser appears to emit only one or two beams.
• NEVER use the laser if the housing is damaged, the housing is open, or if
the optics appear damaged in any way.
• NEVER open the laser housing. The high laser power levels inside of the
protective housing can start fi res, burn skin and will cause instant eye injury.
• NEVER leave this device running unattended.
The operation of a class 3R laser show is only allowed if the show is con-
trolled by a skilled and well-trained operator, familiar with the data from this
manual. The legal requirements for using laser entertainment products vary
from country to country. The user is responsible for the legal requirements
at the location/country of use.
Top/Front
TROUBLESHOOTING
No light output from the unit:
1. Be sure you have connected your unit into a standard wall
outlet.
2. Be sure that the unit is not in blackout mode.
Unit does not respond to sound
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone and/or quiet or high pitched sounds
may not activate the unit.
2. Adjust the sound sensitivity knob located at the rear of the
unit.
SPECIFICATIONS
Model: Pocket Quasar ™
Voltage: 100~240V, 50/60Hz
12VDC Adaptor, 500mA
Power Cons.: 7W
Lasers: 50mW Green Diode
100mW Red Diode
Projection Angle: 70 Degrees
Dimensions: 2”(L) x 4.75”(W) x 3.5”(H)
50mm x 120mm x 90mm
Colors: Green & Red Laser
Weight: 1 Lbs. / .6 kgs.
Duty Cycle: None
Sound Active: Yes
Working Position: Any Safe, Secure Position
Warranty: 2 Years
Specifi cations and improvements in the design of this unit and this manual
are subject to change without any prior written notice.
Laser Output
Mode Button
LED Indicator
Microphone
Remote Sensor
12VDC Power In
Green Laser Dimmer
Cooling Fan
Sound Active
Mode
Power
Select Auto Mode or
Auto/Sound Active
Switch Mode
Select the Laser Color
(Red, Red + Green,
Green)
Program Select, 1-9
Program 1-9: Displays different
static/moving programs