Blizzard Lighting Rocklite Raygun(Rev A) - Manual (Page 12)

Page 12
ROCKLITE RAYGUN Manual Rev. A Copyright (c) 2012 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller in one of 2 channel modes.
1.) The default mode for the fi xture is DMX, which appears as
A001
on the LED
Readout.
2.) To select the DMX personality (channel mode), select either
3 Ch
(3-Chan-
nel Mode), or
5 Ch
(5-Channel Mode), then hit to confi rm.
3.) Then, use the buttons to select the correct address between
A001-A512
, then hit to confi rm.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To set the fi xture in one of 3 standalone automatic operating modes, select
RuN 0 - RuN 2
To confi rm, press the button.
2.) To set the fi xture to a specifi c color (or color scroll), use the
to reach
P000-P255
. This value corresponds to the DMX value for the color
channel you wish to display. For instance, to display Yellow, you would select
a value between
P080-P111
. To select a medium-speed clockwise color
scroll, you would select a value around
P160
, then press the button
to confi rm. (See DMX Values on P. 13)
3.) Next, use the
L000-L255
. This value cor-
responds to the DMX value for the dimmer channel. For instance, to cause the
fi xture to output at approximately 25%, you would select a value of
L064
. To
cause the fi xture to output at 100%, you would select
L255
, then press the
button to confi rm.
4.) To set the fi xture as a slave unit, select
A001
, and hit .
Sound Active Mode:
1.) To use sound active mode, select
Soud
, then press the button
to confi rm.
To Turn the LED Display On/Off:
Allows the user to enable/display the LED display while the fi xture is in operation.
1.) Use the
LEoN
/
LoFF
2.) Now, select the status by using the and buttons to select
LEoN
(LED Display On), or
LoFF
(LED Display Off). To confi rm, press the
button.