Blizzard Lighting Reanimator - Manual (Page 8)

Page 8
Reanimator Manual Rev. A Copyright (c) 2011-12 Blizzard Lighting, LLC
4. OPERATING ADJUSTMENTS
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) Press the
A001
on the LED Readout. Use the button then the and
buttons to choose a channel between
1
and
512
. Press
again to confi rm.
Master/Slave Mode (Auto/Sound Active):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units. It may be necessary to use a terminator at the
last fi xture. For more information about terminators, see page 8.
2.) Choose a unit to function as the Master. Select from one of the run modes,
RUN1-RUNF or sound activation. The master unit must be the fi rst unit. Finally,
chain the units together using DMX cable.
Master
RUN1-F
then to confi rm.
3.) Select slave function by using the / keys to reach A001 in
the menu on the slave units, and they will react in the same as the Master.
Slave
A001
then to confi rm.
4.) On the master fi xture, use the //
RUN1-F/Soud, which allows you to select the Master/Slave mode.
Sound active
SoUd
then to confi rm.
Auto mode
RUN1-F
then to confi rm.
Pattern Playback Adjustments:
Allows you to adjust the playback characteristics of the automatic programs.
Run1 - Run F
then to confi rm.
Each program is different. Perhaps you should study them in depth and write a
short treatise on the differences. Otherwise, just enjoy them all!
L001-L255
then to confi rm.
Adjusts the number of patterns to display
F001-F255
then to confi rm.
Adjusts the number of frames to display of each animation
P000-P255
then to confi rm.
Animation speed (Slow <--> Fast)
LEon
= LED Control Panel remains on
LoFF
= LED Control Panel shuts off after approximately 30 seconds.