Bushnell 98-1214/05-08 - Manual (Page 7)

7
oPErational suMMarY
While holding the product in your hand at arm-length, turn the unit ON by quickly pressing and releasing
the trigger with your index finger. All liquid crystal segments and icons will initially be displayed. The
trigger is located underneath the objective lenses and when depressed again for ranging generates an
audio beep. Next, look through the red dot sighting system and locate the red dot. The object you intend
to acquire distance to can easily be targeted by placing the red dot upon the object.
The PinPro features two targeting modes, PinFire Mode and Non-PinFire Mode. When a target is acquired
in PinFire Mode the audio alarm sounds two beeps and distance is displayed on the external LCD.
When a target is acquired in Non-PinFire Mode the audio alarm sounds three beeps and the distance
is displayed on the external LCD. Once the unit is ON, PinFire Mode is initiated by a quick press and
release of the trigger. PinFire Mode should be used when the REFLECTIVE prism is attached to the top of
the flag stick. While in this mode, the laser pulses will continue firing for approximately 5 seconds and
then stop.
If the trigger is pressed and held the unit will go into Non-PinFire Mode and will hit most anything
without a reflective prism to 450 yards. This mode can be activated by pressing the trigger button after
2-3 seconds of PinFire mode. You may either hold the button from the initial press, or press and hold the
trigger anytime after the ~2-3 seconds of PinFire Mode (i.e. quick press-release, wait ~2-3s, press and
hold). Non-PinFire Mode is maintained as long as the trigger is pressed, a valid reading is obtained, or
the timeout expires.