Vortex Optics SUMMIT SS TRIPOD - Manual (Page 2)

- 6 - - 5 -
- 8- - 7 -
Adjusting the center column
Loosen and tighten the Column Height Adjustment Knob to
raise or lower the center column.
Column Height
Adjustment Knob
For very low heights, the center column can be split by unscrewing and
removing the lower section.
Lower Section of Center
Column Removed
Adjusting the leg length
Adjusting the leg angle
The legs of the Summit SS can be set at one of three angles. To adjust
the leg angle, slide the Release Tab to the right and pivot the leg
outward to the desired angle.
Twist to Lock
and Unlock Leg
2. Pivot Leg and
Engage Release Tab at
Desired Angle 1. Push Release
Tab to Right
Grasp the rubber section at the very end of the tripod leg and rotate
counter-clockwise until you have felt four distinct
clicks. While maintaining grip on rubber end section,
extend the leg to desired length. When leg is at desired
length, twist the rubber end section clockwise to lock in
place. Leg will extend to a maximum of five sections.
To collapse the legs, grasp the rubber end section and
rotate counter-clockwise until you have felt four clicks.
Locks will then be released and leg can be collapsed.
Twist clockwise to re-lock legs.
© Vortex Optics
Visit vortexoptics.com for more information. Canadian customers
may visit vortexcanada.net for customer service information.
T
HE
V
ORTEX
3-Y
EAR
W
ARRANTY
This tripod is warranted to be free of defects in materials and
workmanship for three years after purchase. If
found to be defective in materials or workmanship
upon our inspection, Vortex Optics will repair or
replace the product or part.
Rest assured, if your tripod should ever require
repair, all you need do is contact Vortex Optics at 800-426-0048 for
prompt, professional, and friendly service.
Vortex Optics
2120 West Greenview Drive
Middleton, WI 53562
[email protected]
Manual #ST-4-11A