Swiss+Tech BodyGard Personal Alarm User Manual
Bodygard, Personal alarm 6-in-1, Battery warnings

Pull tab
before use!
Patent pending. Made in China. BODYGARD
®
is a
registered trademark,
MMMMMMMMI
™ and
MI
™ are
trademarks of Swiss+Tech Products. Specifications are
subject to change without notice.
©2012 Swiss+Tech Products, Solon, OH 44139 USA
This product contains button batteries.
IF SWALLOWED, batteries could cause
severe injury or death in just 2 hours.
SEEK MEDICAL ATTENTION IMMEDIATELY.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
BATTERY WARNINGS:
Limited LIFETIME Warranty
This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free from
defects in workmanship and materials. During the
warranty period, this product will either be repaired or
replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED
TO, IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS+TECH
®
brand product
postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139 USA
BodyGard
®
Personal
Alarm 6-in-1
Battery Replacement
1. Loosen captive screw “C” (screw remains
in battery cover). Remove battery cover.
2. Remove old batteries.
3. Replace with three new LR44 button cell
batteries or equivalent. Position positive (+)
and negative (–) sides as indicated.
4. Replace battery cover. Tighten screw gently.
Attach the Lanyard
1. Disconnect the black
plastic end connecter
from the lanyard.
2. Push its string loop
through the BodyGard
®
hang hole and push the
plastic connector through
the string loop.
3. Reattach the lanyard
Sonic Alarm Use
Press alarm button “A” to turn on. Take care
not to obstruct alarm speaker “a”. Press and
hold button “A” for 2 seconds to turn off.
Flashlight/Flasher Use
Press button “B” to turn on white LED
Flashlight. Press button “B” again to turn off
Flashlight and turn on flashing red LED lights.
Press button “B” once more to turn off.
Breakaway Safety Release
This built-in safety feature automatically
releases the lanyard if it should become
snagged or otherwise strained.
www.swisstechtools.com
1-800-414-8799
ST74094
C
String Loop
Plastic End Connecter
Breakaway
Safety Release
B
A
a
Positive Side (+) Down
Positive Side (+) Up
To Change Attachments from
Key Fob to Belt/purse Clip
1. Using a small flat head screwdriver or
fingernail, gently pry up plastic catch “C”
to release the Key Fob
insert. Slide the insert
out toward the
BodyGard
®
back.
2. Insert the
Belt/purse Clip
attachment into
the empty
socket until the
plastic catch
clicks into place.
These attachments
may be interchanged
as often as you like.
Gently pry up
plastic catch
“C” here.
C
Insert
Belt/purse Clip
attachment.