Brother BES-1261BC - Manual (Page 29)

Chapter 1 Preparation of Embroidery Machine
BES-961BC
•
BES-1261BC 27
q
e
Lower by 1 mm
Pin
i
o
u
y
t
4. Mount four thumb bolts
i
each on the rear of F table R
t
, M (2 pcs.)
y
, and L
u
.
5. Mount five thumb bolts on the steel pipe below the front leg.
6. Insert the pins attached to the rear of the F table R
t
, M (2 pcs.)
y
, and L
u
into the cover
o
on the leg. Adjust the height of the F table guide U
q
and the F table support F
e
so that the
table top surface will become 1 mm lower than the bed top surface. After adjustment is
finished, tighten each bolt securely.