MK Diamond MK-212 - Manual (Page 14)

14
UNPACKING
Your MK-212 has been shipped from the factory thoroughly inspected. Only minimal assembly is
required.
Use proper lifting techniques when lifting the MK-212.
I n your container, you will find one (1) MK-212 Saw, (4) or (6) MK-212 support legs, (1) blade wrench,
(1) 2-piece protractor (1) drain plug, (1) rip guide, (1) 5/16" allen wrench, (1) 5mm allen wrench, (1)
owners manual, (1) pump manual and (1) warranty card.
1. The MK-212 weighs approximately two hundred and twenty-six (226 to 270) pounds and for that
reason should not be transported without a minimum of two persons present.
2. Never transport the MK-212 with water in the Water Pan.
3. Move Cutting Head to center and lock down when being carried by person.
MK-212 SAW UNPACKING
Lift Point
Cutting Head
Locked Down
CAUTION
TRANSPORT
MK-212 Saw Rip
Guide
2-Piece
Protractor
Drain
Plug
Blade Wrench MK-212
Support Legs
Warranty
Card
MK-212 SERIES OWNERS MANUAL & OPERATING INSTRUCTIONS
www.mkdiamond.com
MK Diamond Products, Inc.
Caution: Read all safety and operating instructions before
using this equipment. This owners manual MUST accompany the equipment at all times.
04.2009 Revision 301 Manual Part No. 159862
MK-212 SERIES OWNERS MANUAL & OPERATING INSTRUCTIONS
www.mkdiamond.com
Caution: Read all safety and operating instructions before
using this equipment. This owners manual MUST accompany the equipment at all times.
05.2010 Revision 301 Manual Part No. 159862
MK-212-4
MK-212-6
Owner's
Manual
Pump
Manual
5/16" Allen
Wrench
5mm Allen
Wrench
Lift Point
NOTE: The Cutting Head end will be heavier
than the opposite end. Add block or packing
material under Cutting Head (as shipped) for
transporting via vehicle.
CONTENTS